Lab 4 task 3.2
Hey guys, here is my quesiton....
The task requirements is:
• Create two Loopback interfaces in R5 and SW2 with IPv6 addresses 2001:150:X:Y::Y/64 and advertise them into OSPFv3 area 1
• Configure R1 to advertise a summary encompassing both Loopback subnets to R2.
• This summary should overlap the minimum amount of address space necessary.
After create the loopback interface , the summary would be 2001:150:1:1::/60...ok no problem....
My problem is: Configure R1 to advertise a summary encompassing both Loopback subnets to R2.
The question is telling you to configure R1 to advertise a summary , but R1 doesn't have ipv6 routing enable.
The answer will be set up the summary on R2.........but I dont understand why the question says: Configure R1.......
I think that I am missunderstand something when I am passing through the workbook.