OER: How to configure Active probe ?
Topology : Rx--MC --- BR1 ---- Ry
--- BR2 ----
I want MC to ACTIVEly probing for best exit from Rx to Ry but i cannot get the OER active probe working.
This's my active probe configuration (assuming basic OER config is in place):
active-probe address source interface Loopback0
mode route control
mode monitor active
active-probe echo <Ry>
ip sla responder // i don't see icmp echo trigger from BR1 or BR2 ??
I try using oer-map but also not working
MC : ip access-list extended Rx-Ry permit ip host <Rx> host <Ry>
match ip address access-list Rx-Ry
set active-probe echo <Ry>
What i'm missing here ? can somebody give a hint ? thanks.