Task 2.1: Frame Relay dlci maps to 0.0.0.0 - why ?

I have this funny problem where with frame relay encap enabled on serial1/0 interface on R2, R3, R4 routers, all the dlci keep mapping to 0.0.0.0 address even though IP addresses are correctly configured on all remote interfaces.

I am using Dynamip (as you expect) with the .net file from Internetworkexpert.com. I did not make any changes to the FRSW section of this file at all!!!

Example:
# sh frame-relay map

Serial1/0 (up): ip 0.0.0.0 dlci 201(0xC9,0x3090)
broadcast,
CISCO, status defined, active


And here is my sample configuration on one of the serial link

interface Serial1/0
ip address 132.1.0.2 255.255.255.0
encapsulation frame-relay
serial restart-delay 0

Comments

Sign In or Register to comment.