Task 2.1

In task 2.1 says "Using only physical interfaces configure a fully meshed Frame Relay
network between R1, R2, R3, and R4.
• Do not use any static layer 3 to layer 2 mappings over these Frame Relay
connections"

This means that we need to use inverse arp for connectivity but in the solution it provide 105 and 113 DLCI: Could you please tell where this DLCI shown on the diagram? not able to find 105 and 113 DLCI on the frame-relay circuit.

interface Serial0/0
ip address 132.1.0.1 255.255.255.0
encapsulation frame-relay
no frame-relay inverse-arp IP 105
no frame-relay inverse-arp IP 113



Comments

  • Hi Amit,
    If you look carefully, you will notice a 'no' frame-relay..

    no frame-relay inverse-arp IP 105
    no frame-relay inverse-arp IP 113

    The idea here is to delete the dynamic mapping for these links, basically to avoid unnecessary connections.

    try the 'sh frame map' command and you will understand better.
    also try 'sh pvc | i DLCI'

    HTH
Sign In or Register to comment.