GRE
hi, is it possible to configure 2 tunnel GRE on the same interface like this ?
interface Tunnel0
ip unnumbered F0/2
tunnel source F0/2
tunnel destination y.y.y.y
interface Tunnel1
ip unnumbered F0/2
tunnel source F0/2
tunnel destination x.x.x.x
thank for help
Comments
i think this config is valid and u can use it, i havent tested it though
Peace
Yes you can use them. It is better to avoid terminating multiple tunnels on the same interface in real world implementation though. It can cause some performance issues.
We have 50 IPSec VTI
on a main interface and yes its technically possible, but not recommended
though… we overcome with a bigger router with on-board
encrytion
thaks all for your response
We have 50 IPSec VTI
on a main interface and yes its technically possible, but not recommended
though… we overcome with a bigger router with on-board encrytion
From: [email protected] [mailto:[email protected]]
On Behalf Of msaqi
Sent: 31 March 2009 18:03
To: [email protected]
Subject: Re: [CCIE R&S] GRE
Yes you
can use them. It is better to avoid terminating multiple tunnels on the same
interface in real world implementation though. It can cause some performance
issues.
Internetwork Expert - The Industry Leader in CCIE Preparation
http://www.internetworkexpert.com
Subscription information may be found at:
http://www.ieoc.com/forums/ForumSubscriptions.aspx
No
virus found in this incoming message.
Checked by AVG - www.avg.com
Version: 8.0.238 / Virus Database: 270.11.33/2031 - Release Date: 03/30/09
17:56:00