Vol II lab3 task 10.2

Hi Guys,

   For the above Task I used the commands:

ip flow egress

ip flow ingress

under the interface s0/0 of R6 while in the solution it is stating "ip route-cache flow" will this make any difference??

Thanks a lot

 

Comments

  • Hi

    Effective with Cisco IOS Releases 12.4(2)T and 12.2(18)SXD, the ip route-cache flow command is replaced by the ip flow ingress command. See the ip flow ingress command for more information.

    ip route-cache flow = ip flow ingress. It might even be replaced by IOS automatically

    I suppose ip flow egress should not been configured

     

    SPRack1R3(config)#int fas 2/0
    SPRack1R3(config-if)#ip route-cache flow
    SPRack1R3(config-if)#end

    SPRack1R3#sh run int fas 2/0
    Building configuration...

    Current configuration : 111 bytes
    !
    interface FastEthernet2/0
     ip address 10.1.34.3 255.255.255.0
     ip flow ingress

    Jon

     

  • But in the task it says configure for traffic coming from and sent to BB1

     

  • I used both ip flow ingress and ip flow egress.

    Cheers,

    Seba

  • Sorry

     

    did not check lab what was requirement.

    but if requirement is ingress and egress I assume 'ip route-cache flow' cannot be correct

Sign In or Register to comment.