SVI interface as UP/DOWN

I've created an SVI for Management purposes only, so I haven't assigned any int to this SVI,
or set it as an access or Trunk mode.

How can I get the SVI as UP/UP?

My IOS won't allow me use the "no autostate" command against the SVI interface.

**  See the below IOS and model

sh ver
Cisco IOS Software, C3750 Software (C3750-IPBASEK9-M), Version 12.2(50)SE5, RELEASE SOFTWARE (fc1)
Technical Support:
System image file is "flash:/c3750-ipbasek9-mz.122-50.SE5/c3750-ipbasek9-mz.122-50.SE5.bin"

**  See the status of the SVI int

#sh int vlan 5
Vlan5 is up, line protocol is down
  Hardware is EtherSVI, address is 0cd9.966d.3245 (bia 0cd9.966d.3245)
  Description: ### WiFi Management Vlan ###
  Internet address is 10.x.x.129/26
  MTU 1500 bytes, BW 1000000 Kbit, DLY 10 usec,
     reliability 255/255, txload 1/255, rxload 0/255
  Encapsulation ARPA, loopback not set
  Keepalive not supported
  ARP type: ARPA, ARP Timeout 04:00:00
  Last input never, output 06:55:24, output hang never
  Last clearing of "show interface" counters never
  Input queue: 0/75/0/0 (size/max/drops/flushes); Total output drops: 0
  Queueing strategy: fifo
  Output queue: 0/40 (size/max)
  5 minute input rate 0 bits/sec, 0 packets/sec
  5 minute output rate 0 bits/sec, 0 packets/sec
     0 packets input, 0 bytes, 0 no buffer
     Received 0 broadcasts (0 IP multicasts)
     0 runts, 0 giants, 0 throttles
     0 input errors, 0 CRC, 0 frame, 0 overrun, 0 ignored
     3 packets output, 192 bytes, 0 underruns
     0 output errors, 0 interface resets
     0 output buffer failures, 0 output buffers swapped out

**  I've created the relevant vlan, see the below:

sh vlan

VLAN Name                             Status    Ports
---- -------------------------------- --------- -------------------------------

5    WIFI_MANAGEMENT                  active

**  See the SVI L3

interface Vlan5
 description ### WiFi Management Vlan ###
 ip address 10.x.x.129







Sign In or Register to comment.