L3 IPSec tunnel issue

I'm stuck trying to set up L3 IPSec tunnel to the rack. I've copy all the config on the lab guide and change
group coracktest key coracktest
however, i cant ping 11.254.254.254
I'm connecting the the Cisco2811--->Linksys EA3500 wireless router--->Comcast Modem
I logged into my Linksys router to check the firewall but there isn't much setting for firewall. This is what it shows on the Firewall section
====================================================
FIREWALL

IPV4 SPI Protection enable check
VPN passthrough
IPsec passthrough check
PPTP pass through check
L2TP passthough check
INTERNET FILTER
Filter Autonymous Internet request check
Filter multicast uncheck
Fitler internet NAT redirestion uncheck
Filter Ident (port 113) check

=================================================

Tunnel name : INECORACK
Inside interface list: Loopback0
Outside interface: FastEthernet0/0
Current State: IPSEC_ACTIVE
Last Event: MTU_CHANGED
Save Password: Allowed
Split Tunnel List: 1
       Address    : 11.0.0.0
       Mask       : 255.0.0.0
       Protocol   : 0x0
       Source Port: 0
       Dest Port  : 0
Current EzVPN Peer: 75.140.41.126

router#
router#
router#
router#ping 75.140.41.126

Type escape sequence to abort.
Sending 5, 100-byte ICMP Echos to 75.140.41.126, timeout is 2 seconds:
!!!!!
Success rate is 100 percent (5/5), round-trip min/avg/max = 72/75/80 ms

router#ping 11.254.254.254

Type escape sequence to abort.
Sending 5, 100-byte ICMP Echos to 11.254.254.254, timeout is 2 seconds:
.....
Success rate is 0 percent (0/5)

I cant ping 11.254.254.254 or 10.100.64.11

 

Sign In or Register to comment.