Reliable Policy Routing

Hi INE team,

I can't confirm the following note in the solution: "Normally, you would disable R5's DMVPN interface to trigger CDP failure on R1, but on CSR 1000v routers, it seems that CDP next-hop tracking does not work as expected."

It seems as if this bug was fixed in one of the latest releases. See below:

R1#sh cdp nei tu0
Capability Codes: R - Router, T - Trans Bridge, B - Source Route Bridge
                 S - Switch, H - Host, I - IGMP, r - Repeater, P - Phone,
                  D - Remote, C - CVTA, M - Two-port Mac Relay
Device ID        Local Intrfce     Holdtme    Capability  Platform  Port ID

R5               Tunnel0           2                R I   CSR1000V  Tunnel0

Total cdp entries displayed : 1

R1#sh cdp nei tu0

Capability Codes: R - Router, T - Trans Bridge, B - Source Route Bridge
                 S - Switch, H - Host, I - IGMP, r - Repeater, P - Phone,
                  D - Remote, C - CVTA, M - Two-port Mac Relay 

Device ID        Local Intrfce     Holdtme    Capability  Platform  Port ID

Total cdp entries displayed : 0

Running the following release:
Cisco IOS Software, CSR1000V Software (X86_64_LINUX_IOSD-UNIVERSALK9-M), Version 15.4(2)S1, RELEASE SOFTWARE (fc4)

Comments

Sign In or Register to comment.