Task 3.3 - Bridging over FR

Did anybody else run into an issue here?  I configured it as I knew how to, looked at the SG and it was the same, but can't get the interface to pass traffic.  It looks like it's going out, and appears on BB1 that it's working, but I'm not getting the return traffic.  Has anybody else seen this?

Comments

  • Seems like after applying the config, a reboot is required which is odd.  Just thought I'd share.

  • I got this working with the following...  I can't find any reason why this wouldn't work but I am going to post that question in a separate thread.

    bridge irb
    bridge 1 protocol ieee
    bridge 1 route ip
    !
    interface Serial0/0/0.1 point-to-point
    encapsulation frame-relay
    bridge-group 1
    frame-relay interface-dlci 401
    no shutdown
    !
    interface BVI1
    ip address 54.1.10.6 255.255.255.0

Sign In or Register to comment.