Tasked 9 Workbook Volume 1

I am rerout to RL_SLRG_PSNT if SLRG_HQ_PSNT  fails.but the calls are not hitting the H323-Gatway.. I ahve the dial-peers configured probably for the CALLED PARTY.Route-Patterns are good to go. but not hitttign the gateway..however; when i do debug dial-peer voice sum it brings up no matches  however; its hitting the router.. any advise???

Comments

  • Can I see your dial-peers & the part of debug where showing 'called number, 'calling number'?

  • It was my doing.. Thank  alot for you help hoever; when i try to call from the PST to HQPH1 it states ::


      Bearer Capability i = 0x8090A2 

                    Standard = CCITT 

                    Transfer Capability = Speech  

                    Transfer Mode = Circuit 

                    Transfer Rate = 64 kbit/s 

            Channel ID i = 0xA98383 

                    Exclusive, Channel 3 

            Calling Party Number i = 0x4180, '2065015111' 

                    Plan:ISDN, Type:Subscriber(local) 

            Called Party Number i = 0xA1, '2065011001' 

                    Plan:ISDN, Type:National 

            Locking Shift to Codeset 6 

            Codeset 6 IE 0x28  i = 'Seattle US Phone' 

            Codeset 6 IE 0x28  i = 'Seattle US Phone'

    ISDN Se0/0/0:23 Q931: RX <- CALL_PROC pd = 8  callref = 0x8098 

            Channel ID i = 0xA98383 

                    Exclusive, Channel 3

    ISDN Se0/0/0:23 Q931: RX <- SETUP pd = 8  callref = 0x008B 

            Bearer Capability i = 0x8090A2 

                    Standard = CCITT 

                    Transfer Capability = Speech  

                    Transfer Mode = Circuit 

                    Transfer Rate = 64 kbit/s 

            Channel ID i = 0xA18382 

                    Preferred, Channel 2 

            Display i = 'Seattle US Phone' 

            Calling Party Number i = 0x4180, '2065015111' 

                    Plan:ISDN, Type:Subscriber(local) 

            Called Party Number i = 0xA1, '2065011001' 

                    Plan:ISDN, Type:National 

            Locking Shift to Codeset 6 

            Codeset 6 IE 0x28  i = 'Seattle US Phone'

    ISDN Se0/0/0:23 Q931: Received SETUP  callref = 0x808B callID = 0x002D switch = primary-5ess interface = User 16 

    ISDN Se0/0/0:23 Q931: TX -> CALL_PROC pd = 8  callref = 0x808B 

            Channel ID i = 0xA98382 

                    Exclusive, Channel 2

    ISDN Se0/0/0:23 Q931: Applying typeplan for sw-type 0x3 is 0x4 0x1, Calling num 2065015111

    ISDN Se0/0/0:23 **ERROR**: CCPMSG_OutCall: fails with cause 0x22

    ISDN Se0/0/0:23 Q931: TX -> DISCONNECT pd = 8  callref = 0x808B 

            Cause i = 0x80A2 - No circuit/channel available

    ISDN Se0/0/0:23 Q931: RX <- RELEASE pd = 8  callref = 0x008B

    ISDN Se0/0/0:23 Q931: TX -> RELEASE_COMP pd = 8  callref = 0x808B

    ISDN Se0/0/0:23 Q931: RX <- DISCONNECT pd = 8  callref = 0x8098 

            Cause i = 0x82A2 - No circuit/channel available

    ISDN Se0/0/0:23 Q931: TX -> RELEASE pd = 8  callref = 0x0098

    ISDN Se0/0/0:23 Q931: RX <- RELEASE_COMP pd = 8  callref = 0x8098

    ISDN Se0/0/0:23 Q931: TX -> DISCONNECT pd = 8  callref = 0x808A 

            Cause i = 0x80A2 - No circuit/channel available

    ISDN Se0/0/0:23 Q931: RX <- RELEASE pd = 8  callref = 0x008A

    ISDN Se0/0/0:23 Q931: TX -> RELEASE_COMP pd = 8  callref = 0x808A

    CorpHQ#

    i check the channels 

     


    ISDN Se0/0/0:23, Channel [1-24]

      Configured Isdn Interface (dsl) 0

       Channel State (0=Idle 1=Proposed 2=Busy 3=Reserved 4=Restart 5=Maint_Pend)

        Channel :  1 2 3 4 5 6 7 8 9 0 1 2 3 4 5 6 7 8 9 0 1 2 3 4

        State   :  0 0 0 3 3 3 3 3 3 3 3 3 3 3 3 3 3 3 3 3 3 3 3 3 

       Service State (0=Inservice 1=Maint 2=Outofservice 8=MaintPend 9=OOSPend)

        Channel :  1 2 3 4 5 6 7 8 9 0 1 2 3 4 5 6 7 8 9 0 1 2 3 4

        State   :  0 0 0 2 2 2 2 2 2 2 2 2 2 2 2 2 2 2 2 2 2 2 2 2 

     

    ------------ Br1 ph1,, trying to call from the PSTN


    dial-peer voice 1 pots

     incoming called-number .

     direct-inward-dial

    !

    dial-peer voice 101 voip

     destination-pattern 5126022...$

     voice-class codec 1

     voice-class h323 1

     session target ipv4:177.1.10.20

     incoming called-number .

     dtmf-relay h245-signal

    !

    dial-peer voice 102 voip

     preference 1

     destination-pattern 5126022...$

     voice-class codec 1

     voice-class h323 1

     session target ipv4:177.1.10.10

     incoming called-number .

     dtmf-relay h245-signal

    !

    dial-peer voice 911 pots

     destination-pattern 911

     port 0/0/0:23

     forward-digits 3

    !

    dial-peer voice 9911 pots

     destination-pattern 9911

     port 0/0/0:23

     forward-digits 3

    !

    dial-peer voice 103 pots

     destination-pattern 9[2-9]..[2-9]......$

     port 0/0/0:23

    !

    dial-peer voice 104 pots

     destination-pattern 9011T

     port 0/0/0:23

     prefix 011

    !

    dial-peer voice 105 pots

     destination-pattern 91[2-9]..[2-9]......$

     port 0/0/0:23

     prefix 1

     

    -------debug dialpeer voice


    Result=SUCCESS(0) 

       List of Matched Outgoing Dial-peer(s): 

         1: Dial-peer Tag=101 

         2: Dial-peer Tag=102

     

    -------debug isdn q931

     


    ranch1# 

            Display i = 'Seattle US Phone' 

            Calling Party Number i = 0x2180, '2065015111' 

                    Plan:ISDN, Type:National 

            Called Party Number i = 0xA1, '5126022001' 

                    Plan:ISDN, Type:National

    ISDN Se0/0/0:23 Q931: Received SETUP  callref = 0x8097 callID = 0x001A switch = primary-ni interface = User 

    ISDN Se0/0/0:23 Q931: TX -> CALL_PROC pd = 8  callref = 0x8097 

            Channel ID i = 0xA98381 

                    Exclusive, Channel 1

    ISDN Se0/0/0:23 Q931: TX -> PROGRESS pd = 8  callref = 0x8097 

            Cause i = 0x8181 - Unallocated/unassigned number 

            Progress Ind i = 0x8188 - In-band info or appropriate now available 

    Branch1#

    ISDN Se0/0/0:23 Q931: TX -> PROGRESS pd = 8  callref = 0x8097 

            Cause i = 0x8181 - Unallocated/unassigned number 

            Progress Ind i = 0x8188 - In-band info or appropriate now available 

     

  • By the way LOVE your page.. I cant wait to read it later.. I see there are a lot of interesting things there.. I dont think i saw anything about troubleshooting SIP nor H323, do you have any notes on those protocol

  • So after a lil bit more troubleshooting. I did not put the PT_INTERNAL with the CCS_US_DIAL_DEVICE_PSTN.. 

Sign In or Register to comment.