Task 2.11 BGP scan time

After setting the SG's solution (bgp scan-time 5), the debug still shows that the bgp scanner runs every 60 seconds.

Command reference says: "While bgp nexthop address tracking (NHT) is enabled for an address family, the bgp scan-time command will not be accepted in that address family and will remain at the default value of 60 seconds. NHT must be disabled before the bgp scan-time command will be accepted in either router mode or address family mode." (http://www.cisco.com/en/US/docs/ios-xml/ios/iproute_bgp/command/bgp-a1.html#GUID-41436812-87CB-446C-9525-D12E84690DD6).

I think NHT is switched off with "no bgp nexthop trigger enable". After issuing this, the debug still shows that the scanner runs every 60 seconds... Does someone have an explanation?

 

thanks,

Gabor

Comments

Sign In or Register to comment.