Access-group command not accepted.
I'm not sure if this is the correct forum for this post but I'm not seeing any other more suitable formus. I am trying to apply an access list on an ethernet interface of my Terminal Server but the access-group command is not being accepted. Isn't this a basic command that most IOS versions support? I am running 12.3(22) as indicated below.
Cisco Internetwork Operating System Software
IOS (tm) C2600 Software (C2600-I-M), Version 12.3(22), RELEASE SOFTWARE (fc2)
Technical Support: http://www.cisco.com/techsupport
Copyright (c) 1986-2007 by cisco Systems, Inc.
Compiled Wed 24-Jan-07 16:48 by ccai
Image text-base: 0x80008098, data-base: 0x80CEA424
ROM: System Bootstrap, Version 11.3(2)XA4, RELEASE SOFTWARE (fc1)
ROM: C2600 Software (C2600-I-M), Version 12.3(22), RELEASE SOFTWARE (fc2)
TermServ uptime is 55 minutes
System returned to ROM by power-on
System image file is "flash:c2600-i-mz.123-22.bin"
cisco 2610 (MPC860) processor (revision 0x203) with 28672K/4096K bytes of memory.
Processor board ID JAD05040EZ4 (1360388448)
M860 processor: part number 0, mask 49
X.25 software, Version 3.0.0.
1 Ethernet/IEEE 802.3 interface(s)
16 terminal line(s)
32K bytes of non-volatile configuration memory.
8192K bytes of processor board System flash (Read/Write)
Configuration register is 0x2102