EEM CLI pattern synchronization and skip with EEM cli "mode: detection
Hi students ,
I was wondering if anyone from the INE fans played already with the EEM CLI pattern mode detection and the sync and skip at the same time.
Here is a simple EEM example with the configure mode verification , maybe you know how to NOT skip that command while verifying if it was in config mode and still pop the message on the console ?
With this example the skip is done by default.
event manager applet APP_9
event tag 9 cli pattern ".*int.* gi.*" mode "configure" enter
action 9.0 puts "HOLA HOLA"
Thanks for any quick hints on that.
Rack1R4#sh version | i IOS
Cisco IOS Software, 2800 Software (C2800NM-ADVENTERPRISEK9-M), Version 12.4(24)T2, RELEASE SOFTWARE (fc2)