Task 3.3 Bridging

Hi

 i had problem in this task 3.3 bridge from R6---> BB1  i can not p 54.1.10.254... please help

R6

 interface Serial0/0/0
 no ip address
 encapsulation frame-relay
 frame-relay map bridge 401 broadcast
 frame-relay interface-dlci 401
 bridge-group 1
end

RSRack1R6#sh run | i bridge
bridge irb
bridge 1 protocol ieee
bridge 1 route ip


RSRack1R6#ping 255.255.255.255 rep 1

Type escape sequence to abort.
Sending 1, 100-byte ICMP Echos to 255.255.255.255, timeout is 2 seconds:

Reply to request 0 from 144.1.46.4, 1 ms
Reply to request 0 from 54.1.10.254, 32 ms
RSRack1R6#
RSRack1R6#
RSRack1R6#ping 54.1.10.254

Type escape sequence to abort.
Sending 5, 100-byte ICMP Echos to 54.1.10.254, timeout is 2 seconds:
.....
Success rate is 0 percent (0/5)
RSRack1R6#
RSRack1R6#
RSRack1R6#sh arp
Protocol  Address          Age (min)  Hardware Addr   Type   Interface
Internet  54.1.10.6               -   0000.0c36.ede4  ARPA   BVI1
Internet  144.1.46.6              -   001e.f748.c4b8  ARPA   FastEthernet0/0
Internet  144.1.46.4            164   0019.556d.ecf4  ARPA   FastEthernet0/0
Internet  54.1.10.254             0   Incomplete      ARPA  
RSRack1R6#
RSRack1R6#

BB1

BB1#sh run int s1/6.401
Building configuration...

Current configuration : 161 bytes
!
interface Serial1/6.401 point-to-point
 description Bridging over PVC 401 to R6
 snmp trap link-status
 frame-relay interface-dlci 401  
 bridge-group 1
end

BB1#sh run int bv1
Building configuration...

Current configuration : 60 bytes
!
interface BVI1
 ip address 54.1.10.254 255.255.255.0
end

BB1#sh ip int bri | i BVI
BVI1                       54.1.10.254     YES NVRAM  up                    up     
BB1#
BB1#sh run | i bridge
bridge irb
bridge 1 protocol ieee
bridge 1 route ip

Please put the comment why i am not avaiable to Ping BB1 ?

thank in advance

from

 khalid malik

 

 

Comments

Sign In or Register to comment.