ATM Back2Back

I have 2 c7206's installed with PA-A1-OC3 adapters.

Is it possible to connect them directly back2back?

Unfortunately i am experiencing difficulties in getting this to work.

Example configurations would be very much appreciated.

Comments


  •  

    Below running configuration from my rack.

    Tested last week before removing 8510MSR yesterday.

     

     

     

     

    Rack1R2#sh run | be ATM

    interface ATM3/0

     mtu 1500

     bandwidth 155000

     no ip address

     no ip mroute-cache

     load-interval 30

     class-int main

     atm uni-version 4.0

     atm multipoint-signalling

     no atm ilmi-keepalive

     snmp ifindex persist

     no clns route-cache

     pvc 0/5 qsaal

     !

     pvc 0/16 ilmi

     !

    !

    interface ATM3/0.3193 point-to-point

     ip vrf forwarding orkla2

     ip address 10.13.204.106 255.255.255.252

     atm route-bridged ip

     pvc 0/1007

      encapsulation aal5snap

     !

    *********************************************



    Rack1R1#sh run | be ATM

    interface ATM3/0

     mtu 1500

     bandwidth 155000

     no ip address

     no ip mroute-cache

     load-interval 30

     class-int main

     atm uni-version 4.0

     atm multipoint-signalling

     no atm ilmi-keepalive

     snmp ifindex persist

     no clns route-cache

     pvc 0/5 qsaal

     !

     pvc 0/16 ilmi

     !

    !

    interface ATM3/0.3193 point-to-point

     ip vrf forwarding orkla2

     ip address 10.13.204.105 255.255.255.252

     atm route-bridged ip

     pvc 0/1007

      encapsulation aal5snap

     !


    Rack1R1#ping vrf orkla2 10.13.204.106


    Type escape sequence to abort.

    Sending 5, 100-byte ICMP Echos to 10.13.204.106, timeout is 2 seconds:

    !!!!!

    Success rate is 100 percent (5/5), round-trip min/avg/max = 1/2/4 ms

    Rack1R1#





  • Still not working in my set.up.  To be clear i am connect 2 7206's back to back. No atm switch in between.

Sign In or Register to comment.