Task 5.3 - VRF Internet Access

Has anyone been able to verify connectivity in this task. I have checked my configuration against the solution guide and see no difference however am unable to ping any loopbacks on backbone 2 when I source from R7's loopback. I have the default route on R7 and the traffic is getting to R4 when doing a ping and traceroute from R7 however the NAT isn't taking place. Can someone please help? Thx

R4:
!
ip nat inside source route-map NAT_R7_LOOPBACK interface Loopback0 vrf CCIE_SITE_2 overload
!
ip access-list extended NAT_R7_LOOPBACK
!
route-map NAT_R7_LOOPBACK permit 10
match ip address NAT_R7_LOOPBACK
!
ip route vrf CCIE_SITE_2 0.0.0.0 0.0.0.0 24.1.3.3 global
!



Rack1R4#show ip route vrf CCIE_SITE_2

Routing Table: CCIE_SITE_2
Gateway of last resort is 24.1.3.3 to network 0.0.0.0

51.0.0.0/32 is subnetted, 1 subnets
O E2 51.51.51.51 [110/20] via 10.1.47.7, 00:10:59, Ethernet0/0
10.0.0.0/24 is subnetted, 5 subnets
B 10.1.8.0 [200/2] via 24.1.1.1, 00:10:40
O 10.1.7.0 [110/11] via 10.1.47.7, 00:10:59, Ethernet0/0
B 10.1.28.0 [200/2] via 24.1.1.1, 00:10:40
B 10.1.18.0 [200/0] via 24.1.1.1, 00:10:40
C 10.1.47.0 is directly connected, Ethernet0/0
O IA 192.10.1.0/24 [110/11] via 10.1.47.7, 00:10:59, Ethernet0/0
S* 0.0.0.0/0 [1/0] via 24.1.3.3



R7:

Rack1SW1#sh ip route

Gateway of last resort is 10.1.47.4 to network 0.0.0.0

51.0.0.0/32 is subnetted, 1 subnets
O E2 51.51.51.51 [110/20] via 192.10.1.254, 00:11:08, Vlan72
10.0.0.0/24 is subnetted, 5 subnets
O IA 10.1.8.0 [110/3] via 10.1.47.4, 00:11:13, FastEthernet1/4
C 10.1.7.0 is directly connected, Loopback0
O IA 10.1.28.0 [110/3] via 10.1.47.4, 00:11:13, FastEthernet1/4
O IA 10.1.18.0 [110/2] via 10.1.47.4, 00:11:13, FastEthernet1/4
C 10.1.47.0 is directly connected, FastEthernet1/4
C 192.10.1.0/24 is directly connected, Vlan72
O*E2 0.0.0.0/0 [110/1] via 10.1.47.4, 00:11:04, FastEthernet1/4
Rack1SW1#
Sign In or Register to comment.