IEOC - INE's Online Community

Welcome to INE's Online Community - IEOC - a place for CCIE and CCENT candidates to connect, share, and learn. Our Online Community features CCIE forums and discussions for all tracks including Routing & Switching, Voice, Security, Service Provider, Wireless,, and Storage. Through these online communities you can discuss your questions with thousands of your peers, hundreds of CCIE's and INE's own team of world renowned CCIE instructors and authors, Brian Dennis - Quintuple CCIE #2210, Brian McGahan – Triple CCIE #8593, Petr Lapukhov - Quad CCIE #16379, and Mark Snow - Dual CCIE #14073.
Latest post 10-13-2008 6:33 AM by Ricardo Martins. 2 replies.
Page 1 of 1 (3 items)
Sort Posts: Previous Next
  • 10-12-2008 4:09 PM

    no peer neighbor-route command

    Hello experts,


    what's the purpose of "no peer neighbor-route " command in PPP.



    Malick Ndiaye

    "Even a stopped clock is right twice a day" Wink

    • Post Points: 35
  • 10-12-2008 4:58 PM In reply to

    RE: no peer neighbor-route command

    It gets rid of the Connected /32 route distributed from your PPP peer.
    If both sides are sharing the same subnet (which is very typical in today's network) then the /32's showing up doesn't buy much benefit.  In the old days with dialup and many disconnected network connections, it was incredibly important to have!

    Scott Morris, CCIE4 #4713, JNCIE-M #153, JNCIS-ER, CISSP, et al.
    Senior CCIE Instructor


    Internetwork Expert, Inc.
    Toll Free: 877-224-8987
    Outside US: 775-826-4344
    Online Community:
    CCIE Blog:

    Knowledge is power.
    Power corrupts.
    Study hard and be Eeeeviiiil......

    From: [] On Behalf Of ndiayemalick
    Sent: Sunday, October 12, 2008 7:13 PM
    Subject: [CCIE R&S] no peer neighbor-route command

    Hello experts,


    what's the purpose of "no peer neighbor-route " command in PPP.



    Internetwork Expert - The Industry Leader in CCIE Preparation

    Subscription information may be found at:
    • Post Points: 5
  • 10-13-2008 6:33 AM In reply to

    Re: no peer neighbor-route command

    It is just like Scott said.

    If you are using different subnet in both ends you need that command.

    Let me just add if you wanna run ospf or other protocol when using different subnets you need to use ip unnumbered off some interface that is under the ospf process for instance.

    Ricardo Martins
    CCIE #23373 (R&S)

    • Post Points: 5
Page 1 of 1 (3 items)
IEOC CCIE Forums Internetwork Expert CCIE Training
About IEOC | Terms of Use | RSS | Privacy Policy
© 2010 Internetwork Expert, Inc. All Rights Reserved